1.   Place your EZ Wick Setter� in the size container you want to wick. Loosen the thumb screw and allow the wick tube magnet to rest on the bottom of the container.

2.   Push the collar down, depressing the spring until it rests against the stop.  While holding the collar down against the stop, tighten the thumb screw.

Caution:  Do not over tighten the thumb screw.  Now your EZ Wick Setter� is set up for that size diameter and height container.

OPERATING PROCEDURE FOR THE EZ WICK SETTER� TOOL

3.   Apply a glue dot or other adhesive to the bottom of the wick tab. 

4.   Insert the wick into the wick tube until the metal wick tab rests against the magnet. 

5.   Place the EZ Wick Setter� into the container you want to wick.  While holding the EZ Wick Setter� firmly and squarely on the container, depress the handle, setting the wick in the container.  NOTE:  It is not necessary to use excessive force when setting the wick.

6.   Remove the EZ Wick Setter� from the container and repeat steps 3-5 for the remainder of your containers.  You do not need to repeat steps 1 and 2 unless you change to a different size container. 

It's that quick and easy!  Your container now has a wick that is perfectly centered and firmly seated to the bottom of the container.

Note:  When the EZ Wick Setter� is not in use, place it in a container to prevent it from being damaged by rolling off of your work table.